Inserting the Torch into the Cable Tracks: 

If you purchased a Hypertherm® Unit with us, you will have to open the upper and side cable track clips to insert the Hypertherm® Mechanized Torch. First, insert and lock your Torch into the clamp system on the head making sure to set the torch’s tip to be 7.5” inches from the bottom clamp. Open the cable track clips to run your mechanized torch’s cable through the upper cable tracks behind the head and then through the cable track on the lower left side of the table. Confirm your Plasma Cutting Unit is OFF & Unplugged from any power source. Once it has passed through both cable tracks connect the torch lead to your Unit, making sure you do not coil the torch cable. Follow Instructions for your Hypertherm® Unit in the Manual Guide that was provided alongside for any additional setup/preparation your Unit may require.

IMPORTANT: Make sure your Plasma Cutter has a minimum of 6′ feet in distance from the computer and control box. To avoid electrical noise interference, it is desirable to properly allow a distance of 6’ feet between your Hypertherm® System & your computer. Keeping your devices on wood or rubber, will help prevent conductivity.

REMINDER: Remember to turn your Hypertherm® Torch “ON” by switching your torch button to GREEN, found on the side of your torch.

( Click on image to enlarge. )